Do not apply at temperatures below 50 Fahrenheit (10 Celsius)
Before painting, the surface must be clean and free of all surface contamination. This can be done by using sandpaper, cleaning solvents such as xylene, or paper towels to clear rust, debris, water, oil, etc. as necessary.
Mask off all unwanted painting areas that can be exposed to over spray with painters tape.
Some cleaning solvents can remove or damage the original finish. It is highly recommended to test your cleaning solvent in a non conspicuous are before proceeding to the effected area.
Applying The Top Coat
Apply a good even top coat allowing 30-40 minutes between each coat to achieve desired dry film thickness and gloss level if necessary. Allow 24 hours for dry to handle.
Tips & Tricks
To prevent running streaks and orange peal, spray no more than 5 passes over the desired paint area at a reasonable distance allowing 30-40 minutes before applying additional coats.
Multiple coats can increase the gloss level of the first spray finish.
Multiple coats can lighten or darken the color depending on the surface substrate you are spraying on.
The technical data presented is information believed by Crosslink Paints to be currently accurate; however, no guarantee of accuracy, comprehensiveness or
performance is given or implied. Performance can fluctuate due to surface preparation technique, method of application, operating
conditions, the material it is applied to or with, and use. It is strongly recommended that products be tested with respect to these factors prior to full