A 100% acrylic polymer latex. A high-solids, fast drying waterborne traffic paint suitable for application by airless or air atomized equipment at film thicknesses up to 22 mils. May be used to stripe roadways, airports and parking lots with or without pressure applied glass beads. It offers all of the benefits of a water reducible paint, and quickly dries to a no track condition.
The Ennis-Flint 985200 by PPG series meets or exceeds the US Federal specification TT-P-1952F Type 1 and Type 2. Making it ideal for federal Projects or any other heavy traffic application
Advantages:
- Waterborne product does not sustain combustion
- Below 100 VOC
- Product reduces and cleans up with water
- Performs equally well on both asphalt and concrete
- May be applied up to 22 wet mils thick
- excellent bead retention with both standard beads keeps traffic control to a minimum when striping
- Can be used for symbols, legends, and lane marking
Applications: Concrete and asphalt
Coverage: 1-Gallon yields 320 feet of 4" stripe @ 15 mils; 220 feet of 4" @ 22 mills.
Dry Time: Without drop on glass beads, this paint dries to a lab ASTM D711 no pickup in less than 10 minutes @ 15 mils when ambient and surface temperature are 77° F at 50±5% humidity. When glass beads are applied at a rate of at least 6 pounds per gallon to a 15-mil wet line, the field applied paint will dry to an ASTM D713 no-track in less than 2 minutes when applied at the weather conditions above. A 22-mil line should dry in less than 3 minutes when field applied as described above. Dry time is temperature, humidity, and film thickness dependent.
Surface Preparation: All surfaces must be clean, dry and free from oil, grease, antifreeze, loose sand, aggregate and chipping/peeling existing striping. Any curing compounds used on new concrete must be mechanically abraded off prior to striping. When striping on freshly sealed surfaces use caution as some sealers can affect the curing and adhesion of traffic paint. When in doubt, always test adhesion.
